How to solve the multi-process woodworking engraving machine can not be the origin?

       Many customers of woodworking engraving machines often encounter failures in which the engraving machine cannot return to the origin of the machine. Lightly, the woodwork products are paralyzed, and the whole piece will be destroyed. This fault is often found in ordinary woodworking engraving machines, and multi-step woodworking engraving machines are automatic tool changers. Generally, this problem does not exist. So how to solve this fault? In general, the failure of the woodworking engraving machine to return to the origin is caused by the following reasons:

       1. The drive has failed or is damaged.

       2. The motor line is faulty or not connected.

       3. The control card is faulty or loose or damaged, which is common in pirated control cards.

       4. The limit switch or data line is faulty or not inserted.

       5. The machine is set back to the origin in the opposite direction or set incorrectly.

       Can not return to the origin is generally caused by the above reasons, here also reminds the big customers, try to spend more money to buy genuine control system, a good choice is to buy multi-process woodworking engraving machine and other automatic tool change engraving machine equipment.