How can we improve the processing technology of metal engraving machines?

        The metal engraving machine is a high-speed engraving equipment. In recent years, the metal engraving machine has replaced the traditional hand-carving work in a large amount, which provides an important guarantee for the mass production and rapid production of the enterprise, and the development of the enterprise. Created irreplaceable credit. In the same way, how to improve the processing speed of metal engraving machine and provide important support for the development of the enterprise will be the main content of this discussion.

First of all, to strengthen the processing speed of the metal engraving machine, we must first grasp the common faults and solutions of the engraving machine motor.

1. If there is noise in the metal engraving machine motor, it is generally because the motor has a fault inside, it needs to be solved after the sale; or it may be because the motor load is too large, the speed can be adjusted appropriately.

2, the engraving machine motor is hot; this situation is mainly caused by the heat dissipation system of the metal engraving machine, then it is necessary to check whether the circulating water and the pump work normally.
3. When the metal engraving machine motor reverses, this situation is usually caused by the lack of phase of the motor line, and the output UVW end can be directly exchanged.

4. If the motor speed of the engraving machine is slow, then there may be a problem with the power of the engraving machine motor. At this time, we can first check whether the cable is short-circuited, or it may be caused by the lack of the motor line. .

        Secondly, the depth of the lower knife is determined according to the difference of the engraving materials to improve the processing speed of the metal engraving machine.

If you are engaged in engraving work, the most important point is to determine a reasonable amount of cutting tool according to the hardness of the engraving material and the performance of the engraving tool, which is the depth of each layer of the knife we ​​usually say. The tools of different engraving materials will have a maximum amount of knives. When we use metal engraving machine, we should try not to use the maximum knives of the knives. Because of the long time processing, the knives are damaged faster. Moreover, the speed is not improved when the maximum amount of knife is processed, and the speed is likely to cause the knife to be broken. Therefore, we should set the amount of the lower knife to two-thirds of the maximum amount, so that the tool life will be greatly increased, and the processing speed can be improved a lot. This saves both tooling costs and processing efficiency. When the engraving experience is lacking, we can first carry out roughing to see the engraving effect according to the actual situation, and then carry out finishing. In the roughing process, the entire allowance is removed as much as possible to save the finishing time; tool materials with better processing properties can also be used.

Of course, there are many ways to improve the processing speed of the engraving machine. This paper analyzes how to improve the machining speed of the metal engraving machine by introducing the solution to the failure of the engraving machine motor and how to determine the maximum amount of undercut for the engraving machine. As long as you master the operation method of the engraving machine and have a comprehensive understanding of the full engraving machine, it is worthwhile to use various methods to improve the processing speed of the metal engraving machine in busy work.