Woodworking engraving machine jump knife failure solution

In the case of a woodworking engraving machine jumping knife failure, in fact, it is a comprehensive problem, then how to solve the problem of jumping knife?

The failure of the CNC woodworking engraving machine is generally caused by the inconsistent center of the rotation center of the engraving machine and the center of the engraving machine tool during the machining process. When the spindle of the engraving machine is running at high speed, if the spindle of the engraving machine and the tool are not inconsistent, it will not only affect the machining accuracy and processing effect, but also easily cause the broken knife and waste.

Solving the problem of woodworking engraving machine jumping knife Firstly, the engraving machine should try to select the tool with high strength, sharp and smooth front rake surface during the machining process, and try to use up-cutting in finishing. The second is to pay attention to the correctness of the knife when you are on the knife. And to ensure that the chuck, the nut is clean, there is no dust.

Small knowledge necessary for engraving machine maintenance

Many dealers say that they don’t have to maintain the rigid boards they sell when they sell them. The woodworking engraving machine is broken and repaired. Although the maintenance of the cutting plotter is very simple, it is very convenient to change some parts as usual. It is very convenient, but if it is not well maintained, it will be repaired once in a few months. Although it is not necessary to pay the maintenance fee during the warranty period, the lost work is not so good. . Therefore, the user should only take care of the maintenance, unless it is necessary to carry out repairs. So what maintenance do users have to do? Let’s take a brief narrative of the places where problems arise due to poor maintenance:
Trolley cable: Domestically used cable is similar to tape measure. Users can replace it with a tape measure. It is easy to break during scrolling. Therefore, users should promptly mediate when they hear this department have a very loud voice. Don't wait for it to break. Only after the repair, this department is usually not guaranteed.

Limiter: Some rigid cars move to one end to stop when they are initialized. If the car moves continuously and hits the board, and clarifies that there is a problem with the limiter, probably the limiter does not detect the car. It is probably that the positioning component on the car does not reach the position of the limiter, and the department can be mediated. If the car does not move when it is initialized, it is usually because there is too much dust, blocking the metering department in the limiter, which is too thin to usually remove dust.