How is the engraving machine pvc carved burr?
1, the spindle speed problem: normal is generally between 2000-24000 rpm, the spindle speed is too low, there will be burrs
2, the material itself is raw.
3. The tool is not suitable.
4, the tool is not replaced for a long time, the blade wear and tear.
5, the tool is not replaced for a long time, the blade wear and tear.
6. If the amount of knife is too large or too small, it will lead to too much knife: the cutting force is too large, the tool deformation is large, and the processed surface is not smooth; the amount of knife is too small: the phenomenon of processing slippage occurs, resulting in The processed surface is not smooth.
7, clockwise processing will cause PVC burrs.
8. This phenomenon can also occur when the machine is unstable.
How to solve the engraving machine pvc carved burrs?
1. Check if the spindle speed is too low. If it is too low, increase the speed.
2, check whether the material itself is raw, if it is, then replace the quality of other brands of pvc.
3. Check if the tool is suitable for PVC processing.
4. Check if the tool is worn. If it is worn out, replace it with a new one.
5. Check if the parameter settings are correct. If it is not correct, adjust it.
6, check the status of eating knife.
7. Check if the processing is counterclockwise, if not, please adjust it.
8. Check if the engraving machine is loose or not. If it is loose, tighten it.
Through the above-mentioned troubleshooting and adjustment, the engraving machine pvc carved burrs should be solved.
How to deal with the engraving machine pvc carved burrs?
After cutting, the edge burrs are removed by a blade. If there is uneven cutting (such as the movement of the plate leaving a knife mark), it can be flattened with a small shovel.
The processing of the engraving machine pvc carved?
1. PVC can be bonded to each other with universal glue and PVC glue. After bonding, it must be pressed with heavy objects. It can be used after 5-12 hours. (Paste with the two-color plate reference above)
2. When spraying, the surface dust and impurities must be cleaned and can be wiped off with alcohol. When painting, except for the front side, each side should be painted at a temperature of about 60-80 degrees from four directions. The primer should be sprayed less and evenly for the first time. After the paint is dried, the second painting can be carried out, after about three to five times.
Engraving machine pvc carved burr more than how, how to solve all understand, everyone has more understanding of the engraving machine and pvc.